Kubota B2401DT, Руководство оператора

Страница: 90 / 95

STORAGE
WARNING
To avoid personal injury or death:
• Do not clean the machine while the engine is
running.
• To avoid the danger of exhaust fume poisoning,
do not operate the engine in a closed building
without proper ventilation.
• When storing, remove the key from the key
switch to avoid unauthorized persons from
operating the tractor and getting injured.
TRACTOR STORAGE
If you intend to store your tractor for an extended
period of time, follow the proper storing procedures.
These procedures will insure that the tractor is ready to
operate with minimum preparation when it is removed
from storage.
1. Check the bolts and nuts for looseness, and tighten
if necessary.
2. Apply grease to tractor areas where bare metal will
rust also to pivot areas.
3. Detach the weights from the tractor body.
4. Inflate the tires to a pressure a little higher than
usual.
5. Change the engine oil and run the engine to
circulate oil throughout the engine block and
internal moving parts for about 5 minutes.
6. Keep the clutch disengaged. If the clutch is left
engaged for a long period of time, the clutch plate
may rust, making clutch disengagement impossible
at the next operation.
(1) Clutch pedal latch (A) Depress
(B) Hook
7. With all implements lowered to the ground, coat any
exposed hydraulic cylinder piston rods with grease.
8. Remove the battery from the tractor. Store the
battery following the battery storage procedures.
(See Battery on page 70)
9. Keep the tractor in a dry place where the tractor is
sheltered from the elements. Cover the tractor.
10. Store the tractor indoors in a dry area that is
protected from sunlight and excessive heat. If the
tractor must be stored outdoors, cover it with a
waterproof tarpaulin. Jack the tractor up and place
blocks under the front and rear axles so that all 4
tires are off the ground. Keep the tires out of direct
sunlight and extreme heat.
IMPORTANT :
• When washing the tractor, be sure to stop
the engine. Allow sufficient time for the
engine to cool before washing.
• Cover the tractor after the muffler and the
engine have cooled down.
REMOVING THE TRACTOR
FROM STORAGE
1. Check the tire air pressure and inflate the tires if
they are low.
2. Jack the tractor up and remove the support blocks
from under the front and rear axles.
3. Install the battery. Before installing the battery, be
sure it is fully charged.
4. Check the fan belt tension.
5. Check all fluid levels (engine oil, transmission/
hydraulic oil, engine coolant and any attached
implements).
6. Start the engine. Observe all gauges. If all gauges
are functioning properly and reading normal, move
the tractor outside. Once outside, park the tractor
and let the engine idle for at least 5 minutes. Shut
the engine off and walk around tractor and make a
visual inspection looking for evidence of oil or water
leaks.
7. With the engine fully warmed up, release the
parking brake and test the brakes for proper
adjustment as you move forward. Adjust the brakes
as necessary.
STORAGE TRACTOR STORAGE
84
B2401DT, B2401DTWO, B2401DTN