Kubota B2401DT, Руководство оператора

Страница: 47 / 95

• Tractor engine will not start if PTO gear shift
lever is in the engaged “ON” position.
2. PTO shaft cover and shaft cap
Keep the PTO shaft cover in place at all times. Replace
the PTO shaft cap when the PTO is not in use. Before
connecting or disconnecting a drive shaft to PTO shaft,
be sure the engine is "OFF" and raise up the PTO shaft
cover.
Afterward be sure to return the PTO shaft cover to the
normal position.
(1) PTO shaft cover
(2) PTO shaft cap (A) Normal position
(B) Raised position
3. Stationary PTO
To park the tractor and use the PTO system (for chipper
or pump, for example), start the PTO system in the
following steps.
1. Apply the parking brakes and place blocks at the
tires.
2. Make sure the shift levers are at “NEUTRAL” , and
start the engine.
3. Set the PTO gear shift lever to “Rear PTO 1st”
position.
4. Set the engine speed to provide recommended rear
PTO speed.
5. Dismount the seat and tilt up quickly.
Engine will stop if there is a delay in tilting up the
seat.
(1) Seat
(2) Clutch pedal
(3) PTO gear shift lever (A) Rear PTO: 1st / Mid PTO: off
(B) Neutral position
NOTE :
• If the PTO system is engaged and you stand
up from the seat or the seat is not tilted
forward, the engine stops and buzzer
sounds automatically after standing up.
PTO OPERATION PTO
B2401DT, B2401DTWO, B2401DTN
41