NVT-E
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
42611 EN
8 of 27
4
Please observe protection
note ISO 16016.
Drawn:
2019-12-06 Pz/Bet
Replacing:
KTR-N dated 2019-02-14
Verified:
2019-12-06 Pz
Replaced by:
To select a menu item and set the values please proceed as follows:
•
Open the main menu via the button
.
•
Select the submenu via the buttons
and
and open the submenu via the button
.
•
If applicable, select the next submenu via the buttons
and
and open it using the button
.
•
Select the requested menu item via the buttons
and
and open the parameter list via the button
.
•
Set the value using the buttons
and
and accept via the button
.
The amended settings are saved and the device returns to the submenu.
•
Exit the submenu by selecting menu item EXIT and press button
to accept.
The device returns to the superordinate menu or measured value display, respectively.
If the button lock is activated, retrieving the menu via button
shows the display
instead of the main menu. The active digit is marked by a dot.
•
Enter the code via the buttons
and
and press the button
to accept.
The active digit shifts to the right by one place. Having entered the 3
rd
digit the main menu is opened.
Having entered an incorrect code, the device returns to measurement display. If you have
forgotten the password, enter the master code 287 to return to the menu.
To unlock the button lock, reset the password with the input 000 in the menu item
in the submenu
Basic
Settings Extended Functions
.
The menu structure is based on the VDMA standard 24574 and following.
The menu has a hierarchy structure. The highest menu level includes recording of the main menu, e. g.
,
,
,
, . Each main menu comprises further submenu items.
The menu items may vary depending on the configuration of the device. Your device may not provide all menu
items described below. You can retrieve the configuration by pressing the button
in the display mode. A 4-digit
code is displayed, e. g.:
Meaning of the 4-digit code tsav:
t: type
s: number of switching outputs
a: number of analogue outputs
v: mounting of device
t = temperature measurement
o = level and temperature measurement
2 or 4
0 or 2
i = standard mounting (installation of
tank)
4
Operation
4.3 Button functions
4.4 Button lock active
4.5 Summary of menu
