CLAMPEX
®
KTR 150
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40812 EN
7 of 9
7
Please observe protection
note ISO 16016.
Drawn:
2017-11-29 Shg/Jh
Replacing:
KTR-N dated 2017-04-27
Verified:
2017-11-29 Shg
Replaced by:
Inspect the fit of shaft and hub for the tolerance specified (see illustration 1).
Clean the hub bore and shaft and afterwards apply a thin-fluid oil (e. g. Ballistol Universal oil or Klüber Qui-
etsch-Ex).
!
Oils and greases with molybdenum disulphide or other high-pressure additives, additives of
Teflon and silicone as well as internal lubricants reducing the coefficient of friction signifi-
cantly must not be used. When mounting the tapers of the clamping set free from oil the
tabular and calculated parameters deviate.
Shift the hub onto the shaft.
If there is a recess, it has to be bridged via a distance ring (see illustration 4 and 5). The distance ring can be
done without if the recess is missing.
"wrong"
"right"
Illustration 4: Clamping element in recess
Illustration 5: Distance ring in recess
If several KTR 150 ring pairs (4 ring pairs at the maximum) are installed, make sure uniform arrangement of
KTR 150 elements (see illustration 6 and 7).
"wrong"
"right"
Illustration 6: Wrong installation of several clamping elements
Illustration 7: Installation of several clamping elements
Observe distance dimension A (see illustration 8, 9
and 10).
Illustration 8: Observe distance dimension A
4
Assembly
4.2 Assembly of clamping set
