CLAMPEX
®
KTR 130 / KTR 131
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40829 EN
7 of 7
4
Please observe protection
note ISO 16016.
Drawn:
2016-12-22 Shg/Jh
Replacing:
KTR-N dated 2014-09-18
Verified:
2016-12-22 Shg
Replaced by:
!
If these hints are not observed or operating conditions are not taken into account with the
selection of the clamping set, the operation of the clamping set may be affected.
In respect of environmental protection we would ask you to dispose of the packaging or products on termination of
their service life in accordance with the legal regulations and standards that apply, respectively.
All clamping sets consist of metal. Any metal components have to be cleaned and disposed of by scrap metal.
A basic requirement to ensure the readiness for use of the drive components is a stock of some clamping sets on
site.
Contact addresses of the KTR partners for spare parts and orders can be obtained from the KTR homepage at
www.ktr.com.
KTR does not assume any liability or warranty for the use of spare parts and accessories
which are not provided by KTR and for the damages which may incur as a result.
If used in hazardous locations the type and size of clamping set (for category 3 only) has to be selected such that
the difference between the peak torque of the machine including all operating parameters and the rated torque of
the clamping hub at least corresponds to a safety factor of s = 2.0.
CLAMPEX
®
clamping sets are not part of EU directive 2014/34/EU, since
this product is a torsionally rigid, backlash-free, frictionally engaged connection with one or more taper clamp-
ing ring(s) by means of several screws.
(Clamping screws have to be secured, e. g. by means of a medium strength adhesive.)
due to the design of clamping sets a fracture/failure is not likely (frictional heat is only caused by improper
assembly/tightening torques, i. e. not with intended use).
4
Assembly
4.3 Disassembly of clamping set
5
Disposal
6
Spares inventory, customer service addresses
7
Advice regarding the use in
hazardous locations according to EU directive
2014/34/EU
