CLAMPEX
®
KTR 125 / KTR 125.1
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40811 EN
7 of 8
4
Please observe protection
note ISO 16016.
Drawn:
15-09-25 Kb/Jh
Replacing:
KTR-N dated 19.07.12
Verified:
15-10-28 Kb
Replaced by:
Disassembly of KTR 125.1:
The clamping set KTR 125.1 is self-locking. You may expect an excessively difficult dis-
assembly.
If the inner and outer ring of KTR 125.1 cannot be released, the process of releasing should be initiated by
means of proper tools (assembly hammer) (see illustration 8).
Take out the clamping set released between shaft and hub.
Illustration 7: Releasing the clamping set KTR 125
Illustration 8: Releasing the clamping set KTR 125.1
!
If these hints are not observed or operating conditions are not taken into account with the
selection of the clamping set, the operation of the clamping set may be affected.
Used clamping sets have to be disassembled and cleaned before assembly. Afterwards ap-
ply thin fluid oil lightly (e. g. Ballistol Universal oil or Klüber Quietsch-Ex).
In respect of environmental protection please dispose of the packaging or products on termination of their service
life in accordance with the legal regulations and standards that apply, respectively.
All clamping sets consist of metal. Any metal components have to be cleaned and disposed of by scrap metal.
A basic requirement to ensure the operational readiness of the drive components is a stock of some clamping
sets on site.
Contact addresses of KTR partners for spare parts and orders can be obtained from the KTR homepage at
www.ktr.com.
KTR does not assume any liability or warranty for the use of spare parts and accessories
which are not provided by KTR and for the damages which may incur as a result.
4
Assembly
4.3 Disassembly of clamping set
5
Disposal
6
Spares inventory, customer service addresses
