SERVICE WORK ON THE CHASSIS
52
B00042-10
–
Inject the liquid into the system until it escapes from hole
of the master cylinder
without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
4 mm (0.16 in)
–
Position the cover with the membrane. Mount and tighten the screws.
10.44
Removing the engine guard (SX
‑
F CAIROLI REPLICA)
B00597-10
–
Remove screws
and the holding bracket. Remove the engine guard.
10.45
Installing the engine guard (SX
‑
F CAIROLI REPLICA)
B00598-01
–
Attach the engine guard on the frame at the rear and swing up at the front.
–
Position the holding bracket. Mount and tighten the screws.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
