KTM Freeride 350 AU, Руководство пользователя, Страница: 45 / 116

12 SERVICE WORK ON THE CHASSIS
43
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 37)
400738-11
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
» If there is noticeable play present:
–
Adjust the play of the steering head bearing. ( p. 43)
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No
resting locations should be noticeable.
» If click positions are noticeable:
–
Adjust the play of the steering head bearing. ( p. 43)
–
Check the steering head bearing and replace if required.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 37)
12.12 Adjusting the play of the steering head bearing
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 37)
S00839-10
Main work
–
Pull out hose

from the front steering head screw.
–
Loosen screws

. Remove screw

.
–
Loosen and retighten screw  .
Guideline
Screw, top steering head M20x1.5 12 Nm (8.9 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws

.
Guideline
Screw, top triple clamp M8 22 Nm
(16.2 lbf ft)
–
Mount and tighten screw

.
Guideline
Screw, top steering stem M8 17 Nm
(12.5 lbf ft)
Loctite ® 243™
–
Insert hose  into the steering head screw.
Finishing work
–
Check the steering head bearing play. ( p. 42)
–
Remove the motorcycle from the lift stand. ( p. 37)
12.13 Greasing the steering head bearing
800010-10
–
Remove the lower triple clamp. ( p. 40)
–
Install the lower triple clamp. ( p. 41)