KTM Freeride 250 R EU, Руководство пользователя

Страница: 39 / 115

11 TUNING THE CHASSIS
37
11.14 Handlebar position
M01029-10
On the upper triple clamp, there are two holes at a distance of

to each other.
Hole distance

15 mm (0.59 in)
The holes on the handlebar supports are placed at a distance of

from the center.
Hole distance

3.5 mm (0.138 in)
The handlebar supports can be mounted in four different positions.
11.15 Adjusting the handlebar position
Warning
Danger of accidents
Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
M01029-11
–
Remove screws

. Remove the handlebar clamps. Take off the handlebar and lay
it to one side.
Info
Cover the components to protect them against damage.
Do not bend the cables and lines.
–
Remove screws

. Take off the handlebar supports.
–
Move the handlebar supports into the desired position. Mount and tighten
screws
 .
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws  and tighten evenly.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
Make sure the gap width is even.