KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 72 / 222

14 WHEELS
70
14.3 Checking the brake discs
Warning
Danger of accidents Reduced braking efficiency due to worn brake disc(s).
–
Change the worn brake disc(s) without delay.
400257-10
–
Check the thickness of the front and rear brake discs at several places on the disk
to see if it conforms to measurement
A
.
Info
Wear reduces the thickness of the brake disc around the area used by the
brake linings.
Brake discs - wear limit
Front 2.5 mm (0.098 in)
Rear 3.5 mm (0.138 in)
» If the brake disc thickness is less than the specified value:
–
Change the brake disc.
–
Check the front and rear brake discs for damage, cracking and deformation.
» If the brake disc shows signs of damage, cracking, or deformation:
–
Change the brake disc.
14.4 Checking the spoke tension
Warning
Danger of accidents Instable handling due to incorrect spoke tension.
–
Ensure that the spoke tension is correct.
Info
A loose spoke causes wheel imbalance and rapidly leads to more loose spokes.
If the spokes are too tight, they can break due to local overload.
Check the spoke tension regularly, especially on a new motorcycle.
400694-01
–
Briefly strike each spoke with the tip of a screwdriver.
Info
The tone frequency depends on the length of the spoke and the spoke diam-
eter.
If you hear different tone frequencies from different spokes of equal length
and diameter, this is an indication of different spoke tensions.
You should hear a high note.
» If the spoke tension varies:
–
Correct the spoke tension.
–
Check the spoke torque.
Guideline
Spoke nipple M4.5 5… 6 Nm (3.7…
4.4 lbf ft)
Torque wrench with various accessories in set (58429094000) ( p. 209)