SERVICE WORK ON THE CHASSIS 3
7
3.7
Sticking on the reflector
F01234-01
–
Make sure that the reflectors are glued on to the left and right
fork leg.
» If there are no reflectors stuck on:
–
Stick on the reflector.
Info
The reflectors must not be covered by trim
parts.
3.8
Installing handlebars
F01235-10
–
Remove screws
1
. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount
and tighten screws
1
.
Guideline
Screw, handle-
bar support
M10
40 Nm (29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
E00957-10
Warning
Danger of accidents
A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
or bent.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten the screws
evenly.
Guideline
Screw, handlebar
clamp
M8
20 Nm (14.8 lbf ft)
