KTM 990 SUPER DUKE, Инструкции по установке

Страница: 8 / 17

3 WORK
6
3.1 Removing the seat
B00165-10
–
Insert the ignition key in the seat lock
1
and turn it clockwise.
–
Raise the rear of the seat, push it towards the rear, and remove it upwards.
3.2 Mounting the seat
B00188-10
–
Hook the tabs
1
of the seat onto the fuel tank, lower the rear and push forward.
The two hooks
2
must engage in the subframe.
–
Turn the ignition key counterclockwise in the seat lock and withdraw it.
–
Finally, check that the seat is correctly mounted.
3.3 Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Caution
Danger of accidents If the vehicle is operated with a discharged battery or without a battery, electronic components and safety
equipment may be damaged.
–
Never operate the vehicle with a discharged battery or without a battery.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the front spoiler. ( p. 8)
B00191-10
Main work
–
Remove the cable binder.
–
Detach the connector from the start relay.
–
Push the wiring harness to the side.
–
Remove screws
1
.
–
Fold cover
2
down.