KTM 85 SX 17/14 2013, Инструкции по установке

Страница: 8 / 15

3 WORK
6
3.1 Raising the motorcycle with the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
L00036-10
–
Raise the motorcycle at the frame underneath the engine.
Lift stand (59229055000)
The wheels must no longer touch the ground.
–
Secure the motorcycle against falling over.
3.2 Removing the motorcycle from the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
L00022-10
–
Remove the motorcycle from the lift stand.
–
Remove the lift stand.
–
To park the motorcycle, insert plug-in stand
1
into the left side of the wheel spin-
dle.
Info
Remove the plug-in stand before riding.
3.3 Installing the front wheel
Warning
Danger of accidents
Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
L00094-11
Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease shaft seal rings
1
and bearing surface
A
of the spacers.
Long-life grease ( p. 11)
–
Insert the spacers.
L00092-11
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel spindle M20x1.5 35 Nm
(25.8 lbf ft)
–
Operate the hand brake lever several times until the brake linings are lying correctly
against the brake disc.
–
Remove the motorcycle from the lift stand. ( p. 6)