KTM 690 SMC R, Руководство пользователя

Страница: 108 / 200

13 WHEELS, TIRES
106
M01388-10
–
Push the rear wheel forward as far as possible and lay the chain on the rear sprocket.
–
Mount wheel spindle

and chain adjuster

. Mount nut

, but do not tighten it
yet.
–
Make sure that chain adjusters  are fitted correctly on adjusting screws  .
–
Make sure that the markings on the left and right chain adjusters are in the same posi-
tion relative to reference marks

. The rear wheel is then correctly aligned.
–
Tighten nut

.
Guideline
Nut, rear wheel spindle M25x1.5 90 Nm
(66.4 lbf ft)
–
Position the wheel speed sensor

in the drill hole. Mount and tighten screw

.
Guideline
Screw, wheel speed sensor M6 6 Nm (4.4 lbf ft)
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
Finishing work
–
Remove the rear of the motorcycle from the wheel stand. ( p. 71)
–
Check the chain tension. ( p. 79)
13.5 Checking the rear hub rubber dampers
Info
The engine power is transmitted from the rear sprocket to the rear wheel via 6 rubber dampers. They eventually wear out during
operation. If the rubber dampers are not changed in time, the rear sprocket carrier and the rear hub become damaged.