KTM 690 SMC R 2016 Series, Инструкции по установке

Страница: 12 / 18

3 WORK
10
3.8 Removing rear fairing
Preparatory work
–
Remove the seat. ( p. 6)
S00811-10
Main work
–
Remove screws

.
100314-10
–
Remove screws

.
–
Open the filler cap. ( p. 9)
–
Take off the rear fairing.
–
Close the filler cap. ( p. 9)
3.9 Fitting rear fairing
S00806-10
–
Position the license plate holder and cable harness.
–
Open the filler cap. ( p. 9)
–
Position the rear fairing and grab handles  as shown in the figure. Fit and
slightly tighten the screws of the grab handles.
–
Close the filler cap. ( p. 9)
–
Fit and tighten the screws on the rear fairing.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
100314-10
–
Mount and tighten screws

.
–
Tighten the screws of the grab handles.
Guideline
Screw, grab handle M8 10 Nm (7.4 lbf ft)
–
Mount the seat. ( p. 6)
3.10 Mounting rear footrest bracket
Info
The operations are the same for the left and right sides.
S00784-10
–
Position the footrest bracket

. Mount and tighten screws

.
Guideline
Screw, rear footrest bracket M8x16 25 Nm
(18.4 lbf ft)