KTM 690 SMC AUS/UK, Руководство пользователя, Страница: 126 / 189

14 ELECTRICAL SYSTEM
124
100160-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully swing turn signal glass
1
forward and take it off.
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until it
stops.
Turn signal (RY10W / socket BAU15s) ( p. 167)
–
Position the turn signal glass.
–
Insert the screw and turn it counterclockwise first until it engages in the thread. Tighten
the screw slightly.
Finishing work
–
Check the turn signal system function.
14.11 Checking the headlight setting
400726-10
–
Stand the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically at a distance
A
in front of the wall.
Guideline
Distance
A
5 m (16 ft)