KTM 690 SMC 2008, Руководство по ремонту

Страница: 22 / 227

01/FORK, TRIPLE CLAMP
20
200668-10
–
Heat up the outer tube in area

of the lower sliding bushings.
Guideline
50 °C (122 °F)
–
Pull the outer tube of the fork off of the inner tube with a jerk.
Info
The lower sliding bushing

must be pulled from its bearing seat.
200658-12
–
Remove the upper sliding bushing

.
Info
Without using tools, carefully pull the stack apart by hand.
200659-12
–
Take off the lower sliding bushing

.
–
Take off support ring

.
–
Take off seal ring

.
–
Take off lock ring

.
–
Take off dust boot

.
5.11
Checking the fork legs
Condition
The fork legs have been disassembled.
200686-10
–
Check the inner tube and the axle clamp for damage.
» If damage is found:
–
Replace the inner tube.
200684-10
–
Measure the external diameter of the inner tube in several places.
External diameter of inner tube 47.975… 48.005 mm (1.88878…
1.88996 in)
» If the measured value is less than the specified value:
–
Replace the inner tube.