KTM 690 SMC 2008, Руководство по ремонту

Страница: 140 / 227

30/ASSEMBLING THE ENGINE
138
19.13
Installing timing chain rails
300046-11
–
Position the timing chain securing guide

.
Info
The cable of the crankshaft position sensor must be laid in the cable chan-
nel of the timing chain securing guide.
–
Thread in the timing chain tensioning rail

from above. Insert the support bush-
ing into the timing chain securing guide.
300045-11
–
Thread in the timing chain guide rail

from above. Insert the support bushing into
the timing chain securing guide.
–
Mount and tighten screws

.
Guideline
Screw, timing chain guide
rail M6 10 Nm
(7.4 lbf ft) Loctite ® 243™
Screw, timing chain ten-
sioning rail M6 10 Nm
(7.4 lbf ft) Loctite ® 243™
Info
Ensure that there is no thread locking material at the collar of the screw;
otherwise, the timing chain tension rail could lock and break.
–
Check both timing chain rails for freedom of motion.
19.14
Installing rotor
300042-10
–
Ensure that the spring washer

is seated properly.
–
Degrease the cone of the crankshaft and the rotor.
–
Mount the rotor.
Info
Make sure that the crankshaft is not blocked.
–
Use the special tool to hold the rotor tight.
Holding spanner (75029091000) ( p. 215)
300043-10
–
Mount the tab washer and the nut

. Tighten nut.
Guideline
Rotor nut M18x1.5 100 Nm
(73.8 lbf ft)
19.15
Adjusting crankshaft position sensor distance
300048-10
–
Adjust the distance between the crankshaft position sensor

and the conductive
element of the rotor using the special tool

.
Guideline
Crankshaft position sensor/rotor - dis-
tance 0.70 mm (0.0276 in)
Feeler gauge (59029041100) ( p. 210)
–
Fully tighten screws

.
Guideline
Screw, ignition pulse gen-
erator M6 10 Nm
(7.4 lbf ft) Loctite ® 243™