KTM 690 Duke USA, Руководство пользователя

Страница: 147 / 182

20 TROUBLESHOOTING
145
Faults Possible cause Action
Engine does not crank when the elec-
tric starter button is pressed Operating error
–
Carry out the start procedure. ( p. 52)
Battery is discharged
–
Recharge the battery. x ( p. 107)
Fuse 1 , 2 or 3 blown
–
Change the fuses of individual power consumers.
( p. 113)
Main fuse burned out
–
Change the main fuse. ( p. 110)
No ground connection present
–
Check the ground connection.
Engine turns only if the clutch lever is
drawn The vehicle is in gear
–
Shift gear to neutral.
The vehicle is in gear and the side
stand is folded out
–
Shift gear to neutral.
Engine turns but does not start Operating error
–
Carry out the start procedure. ( p. 52)
Fuse 3 blown
–
Change the fuses of individual power consumers.
( p. 113)
Coupling of fuel hose connection not
connected
–
Reconnect coupling of fuel hose connection.
Defect in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
x
Throttle opened while starting
–
When starting, DO NOT open the throttle
–
Carry out the start procedure. ( p. 52)
Engine has too little power Air filter is very dirty
–
Remove the air filter. x
–
Install the air filter. x
Fuel filter is very dirty
–
Check the fuel pressure.
x
Defect in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
x
Map
‑
Select switch incorrectly adjusted
–
Set the engine characteristics. ( p. 131)