KTM 65 SX 2019, Инструкции по установке

Страница: 5 / 21

SETUP 2
3
2.1 Unpacking and setting up the vehicle
201951-10
–
Open the box.
Info
To avoid damaging the vehicle while setting it up, do
not remove the protective film on each component until
installing the component, and leave it on the vehicle
until work has been completed.
–
Remove the front wheel, fender, and the separate enclosure
from the box.
–
Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
–
Lift the vehicle out of the box with the assistance of another
person.
–
Raise the motorcycle with a lift stand. ( p. 5)
–
Check the vehicle for transport damage.
201952-10
–
Loosen screws
1
.
–
Remove the wheel spindle.
–
Install front fender. ( p. 10)
–
Install the front wheel. ( p. 5)
–
Remove the protective film from the handlebar and start num-
ber plate.
K00344-10
–
Position the handlebar with handlebar clamps
2
.
–
Mount and tighten the screws.
Guideline
Screw, handlebar
clamp M8 20 Nm (14.8 lbf ft)
–
Check the handlebar position.
» If the handlebar position is not adjusted as required by the
customer:
–
Adjust the handlebar position. ( p. 6)
–
Remove the screw of brake line guide
3
. Position the brake
line. Mount the brake line guide again and tighten the screw.
–
Check that the controls on the handlebar are correctly posi-
tioned and firmly seated.
–
Remove the seat. ( p. 7)
–
Remove the fuel tank. ( p. 8)