KTM 65 SX 1999, Руководство пользователя

Страница: 45 / 91

11 SERVICE WORK ON THE CHASSIS
43
H00129-10
Main work
–
Loosen nut

.
–
Loosen nuts

.
–
Adjust the chain tension by turning the adjusting screws

left and right.
Guideline
Chain tension 5… 8 mm (0.2… 0.31 in)
Turn the left and right adjusting screws

so that the distance of the chain
adjuster to the swingarm is the same on the left and right and the rear wheel is
in line with the front wheel.
–
Tighten nuts

.
–
Make sure that chain adjusters  are fitted correctly on adjusting screws  .
–
Tighten nut  .
Guideline
Nut, rear wheel spindle M14x1.5 40 Nm
(29.5 lbf ft)
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 28)
11.34 Checking the chain, rear sprocket, engine sprocket, and chain guide
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 28)
400227-01
Main work
–
Check the rear sprocket and engine sprocket for wear.
» If the rear sprocket and engine sprocket are worn:
–
Change.the drive set.
Info
The engine sprocket, rear sprocket, and chain should always be
replaced together.
When fitting the chain joint, always make sure that the closed side
of the joint faces forward (riding direction).
–
Check the chain for wear.
» If the chain is worn:
–
Change.the drive set.
Info
When the chain is replaced, the rear sprocket and engine sprocket
should also be changed.
New chains wear out faster on old, worn sprockets.
H00130-10
–
Check the engine sprocket cover for wear.
» If the engine sprocket cover is worn through in the marked area

:
–
Change the engine sprocket cover.
–
Check the engine sprocket cover for tightness.
» If the engine sprocket cover is loose:
–
Tighten the engine sprocket cover.
Guideline
Screw, engine sprocket cover M6 10 Nm
(7.4 lbf ft)