KTM 640 LC4 2002, Руководство пользователя

Страница: 27 / 46

ENGLISH
26
Main fuse
Located near the battery under the seat, the main fuse
1
protects all power
consumers.
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
The fuse capacity is 20 Ampere.
!
CAUTION
!
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
ALLOWED TO BE
“
REPAIRED
”. A
N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
ELECTRICAL INSTALLATION
!
Fuses for individual power-consuming units
Additional fuses separately protecting different power-consuming units are
mounted under the headlight mask.
For instructions to remove and mount the headlight mask please refer to
"Exchanging the headlight lamp".
Fuse
2
(10 Ampere) protects the following power-consuming units:
– headlight
– parking light
Fuse
3 (10 Ampere) protects the following power-consuming units:
– flasher lights
– brake light
– horn
– radiator fan motor
Fuse
4
(10 Ampere) protects the following power-consuming units:
– ignition
– starter system
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
!
CAUTION
!
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
ALLOWED TO BE
“
REPAIRED
”. A
N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
ELECTRICAL INSTALLATION
!
Exchanging the headlight lamp
Remove the headlight mask:
Remove screws
5 on the left and on the right side.
Depress the front section of the fender, pull the headlight mask upwards,
unhook it from the lower part of the fender, then swing it forwards.
Exchanging the headlight lamp:
Disconnect plug
6
from the bulb.
Remove the rubber cap
7
Unhook the retaining bracket, then remove the bulb.
When inserting the new bulb make sure that the wider of the 3 tongues
8
is located in the corresponding groove in the socket.
! CAUTION !
N
EVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS
. T
HE GLASS OF THE BULB
MUST REMAIN ABSOLUTELY FREE FROM GREASE
. H
EAT WILL OTHERWISE CAUSE THE
GREASE TO EVAPORATE AND SETTLE DOWN ON THE REFLECTOR
.
Hook in the retaining bracket, mount the rubber cap and connect the plug
to the bulb.
Mounting the headlight mask:
Appropriately position the headlight mask. The headlight must be
located below the cockpit.
Depress the front part of the fender, pull the headlight mask upwards and
insert the retaining pins
9 into the corresponding bores of the fender.
Mount the screws 5 .
Replacing the parking-light bulb
Disassemble the headlight as described above and simply pull the bulb
socket
bk
out of the reflector.
1
2
3
4
6
7
10
9
8
5