KTM 620 2001, Руководство пользователя

Страница: 34 / 41

ENGLISH
33
4
1
2
3
5
6
7
8
5 6
Changing and bleeding the microfilter *
Replace the microfilter while changing the engine oil. To do so, remove
hexagon screws
1
and take off the microfilter cover
2
. Remove the micro-
filter, clean its parts and check the O-ring on the microfilter lid for signs of
damage. Before installing the new micro filter, soak it in clean engine oil.
Place a new microfilter in the filter housing, apply a thin layer of grease to
the O-ring and mount the microfilter cover.
It is necessary to bleed the micro filter so that all friction areas can be
quickly supplied with engine oil. To do this, fill with oil and remove the jet
screw
4
from the oil line on the clutch cover. Start the engine and close off
the oil filler hole on the clutch cover with a rag. Allow the engine to run at
idle until oil runs out of the oil line
3
. Turn the engine off. Install seal rings
and the jet screw. Torque the jet screw to 10 Nm (7 ft.lb) and check for
leaks.
Changing oil filter *
Replace the oil filter when changing the engine oil. Press the foot brake
lever and place a screwdriver or similar between foot brake lever and stop-
per roll so that the oil filter cover is more accessible. Remove banjo bolt
5
and the three allen head screws. Remove oil filter cover
6
and oil filter.
Clean filter case, oil filter cover, and sealing surfaces. Check oil chanel in oil
filter cover if clogged.
The O-ring 7 need not be replaced unless it is damaged. Press the O-ring
into the groove of the oil filter cover, mount a new oil filter 8 on the oil fil-
ter cap and mount the unit. Insert the 3 screws and tighten them with 5 Nm
(4 ft.lb). Mount the banjo bolt with the gaskets and tighten it with 15 Nm
(11 ft.lb).
Then start the engine and check the oil system for leaks.