KTM 500 EXC SIX DAYS US, Руководство пользователя, Страница: 51 / 132

11 TUNING THE CHASSIS
49
M00993-10
(EXC US)
On the upper triple clamp, there are two holes at a distance of

to each other.
Hole distance

15 mm (0.59 in)
The holes on the handlebar holders are placed at a distance of

from the center.
Hole distance

3.5 mm (0.138 in)
The handlebar holders can be mounted in four different positions.
11.16 Adjusting handlebar position
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
M00987-11
(EXC Six Days US)
–
Remove screws  . Take off the handlebar clamps. Remove the handlebar and
lay it to one side.
Info
Cover the components to protect them against damage.
Do not bend the cables and lines.
–
Remove screws

. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount and tighten
screws

.
Guideline
Screw, handlebar holder M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten screws

evenly.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
Make sure the gap width is even.