KTM 500 EXC AUS, Руководство пользователя

Страница: 49 / 119

11 SERVICE WORK ON THE CHASSIS
47
101489-10
–
Release screws
4
. Take out the left fork leg.
–
Release screws
5
. Take out the right fork leg.
11.8 Installing the fork legs
x
101325-10
Main work
–
Position the fork legs.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
1
toward the front.
101489-11
–
Tighten screws
2
.
Guideline
Screw, top triple clamp M8 20 Nm
(14.8 lbf ft)
–
Tighten screws
3
.
Guideline
Screw, bottom triple clamp M8 15 Nm
(11.1 lbf ft)
101326-10
–
Position brake caliper, and mount and tighten screws
4
.
Guideline
Screw, front brake caliper M8 25 Nm
(18.4 lbf ft) Loctite ® 243™
–
Mount cable binder
5
.
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
6
.
Finishing work
–
Install the front wheel.
x
( p. 74)
–
Refit the headlight mask with the headlight. ( p. 83)
–
Check the headlight setting. ( p. 85)
11.9 Removing the fork protector
x
Preparatory work
–
Remove the headlight mask with the headlight. ( p. 83)
–
Raise the motorcycle with the lift stand. ( p. 45)
–
Remove the front wheel. x ( p. 74)
–
Remove the fork legs. ( p. 46)