01/FORK, TRIPLE CLAMP
17
–
Tighten screws
.
Guideline
Screw, bottom triple clamp
M6
10 Nm (7.4 lbf ft)
–
Repeat these steps on the opposite side.
–
Tighten nut
.
Guideline
Nut, steering stem
M20x1.5
10 Nm (7.4 lbf ft)
300742-10
–
Position the handlebar support.
–
Mount and tighten screws
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
300743-10
–
Position the handlebar with handlebar clamps.
–
Mount and tighten screws
.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
–
Position the fuel tank breather
.
300732-12
–
Position the brake caliper, fit and tighten the screws
with washers.
Guideline
Screw, front brake caliper
M8
20 Nm
(14.8 lbf ft)
Loctite
®
243™
300731-12
–
Position the brake line. Put the clamp on, and mount and tighten screws
.
–
Install the front fender. (
–
Install the start number plate. (
–
Install the front wheel. (
–
Check that the wiring harness, throttle cables and brake line have freedom of move-
ment and are routed correctly.
–
Check play of steering head bearing. (
4.11
Greasing the steering head bearing
400563-01
–
Remove the lower triple clamp. (
–
Install the lower triple clamp. (
PartShark.com