KTM 50 SX 2017, Руководство пользователя

Страница: 34 / 104

10 TUNING THE CHASSIS
32
0 0 1 1
0 0 2 2
400564-10
–
Remove the screws

. Take off the handlebar clamps. Remove the handlebar and
lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the screws

. Remove the handlebar support.
–
Place the handlebar support in the required position. Fit and tighten the
screws

.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Fit and evenly tighten the screws

.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
Make sure the gap width is even.
10.17 Adjusting the seat height
Warning
Danger of accidents Modifications to the suspension settings can seriously alter the vehicle's ride behavior.
–
Following modifications, ride slowly at first to get the feel of the new ride behavior.
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 34)
V00264-10
Main work
–
Remove nut

.
V00265-10
–
Hold the rear wheel with the swingarm and remove screw

.
–
Position the shock absorber according to the required seat height.
Guideline
Low seat position (standard)

High seat position

–
Position screw

.