KTM 390 Duke 2015 COL, Руководство пользователя

Страница: 50 / 182

6 CONTROLS
48
401308-01
–
Press the MODE button briefly and repeatedly until TRIP 2 appears on the display.
–
Press the SET button for 5 - 10 seconds.
The display RPM 2 appears.
Info
The engine speed can be set at intervals of 50.
RPM 2 is the engine speed above which the shift warning light lights up con-
stantly.
The speed
RPM 2
must always be higher than the speed
RPM 1
.
–
Set the speed with the MODE and SET buttons.
Info
The MODE button increases the value.
The SET button decreases the value.
–
Do not activate the two buttons for approx. 15 seconds.
The display RPM 2 goes out and the set speed is stored.
6.12 Opening the filler cap
Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no fuel is
spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.