KTM 300 EXC, Руководство по ремонту

Страница: 171 / 289

18 ENGINE
169
18.4.27 Checking the electric starter drive
303006-10
–
Check the gear mesh and bearing of starter idler gear
1
for damage and wear.
» If there is damage or wear:
–
Change the starter idler gear.
–
Check the gear mesh and bearing of Bendix
2
for smooth operation, damage and wear.
» If damaged or worn, or if the Bendix does not move easily:
–
Change the Bendix.
–
Check the gear mesh of starter motor
3
for damage and wear
» If there is damage or wear:
–
Change the starter motor.
–
Change O-ring
4
of the starter motor.
–
Connect the negative cable of a 12 volt power supply to the housing of the starter motor. Connect the positive cable of the power
supply briefly with the connector of the starter motor.
» If the starter motor does not turn when the circuit is closed:
–
Change the starter motor.
303062-10
–
Mount the starter idler gear in the alternator cover.
–
Mount cover
5
with the gasket.
–
Mount and tighten screws
6
.
Guideline
Screw, alternator cover M6 8 Nm (5.9 lbf ft)
–
Mount and tighten a fitting screw
7
with the washer and nut.
Guideline
Screw, alternator cover M6 8 Nm (5.9 lbf ft)