KTM 250 SX-F US, Руководство пользователя

Страница: 27 / 112

9 SERVICE SCHEDULE
25
9.1 Additional information
Any further work that results from the required work or from the recommended work must be ordered separately and can be invoiced
separately.
9.2 Required work
Every 30 operating hours
Every 20 operating hours
Every 10 operating hours/after every race
Once after 1 operating hour
Read out the fault memory using the KTM diagnostics tool.
○ ● ● ●
Check and charge the battery.
● ● ●
Check the front brake linings. ( p. 63)
● ● ●
Check the rear brake linings. ( p. 67)
● ● ●
Check the brake discs. ( p. 61)
● ● ●
Check the brake lines for damage and leakage.
● ● ●
Check the rear brake fluid level. ( p. 66)
● ● ●
Check the free travel of the foot brake lever. ( p. 65)
● ● ●
Check the frame and swingarm.
● ● ●
Check the swingarm bearing for play.
●
Check the shock absorber linkage.
● ● ●
Check the tire condition. ( p. 72)
○ ● ● ●
Check the tire air pressure. ( p. 73)
○ ● ● ●
Check the wheel bearing for play.
● ● ●
Check the wheel hubs.
● ● ●
Check the rim run-out.
○ ● ● ●
Check the spoke tension. ( p. 73)
○ ● ● ●
Check the chain, rear sprocket, engine sprocket, and chain guide. ( p. 56)
● ● ●
Check the chain tension. ( p. 55)
○ ● ● ●
Grease all moving parts (e.g., hand lever, chain, ...) and check for smooth operation.
● ● ●
Check/rectify the fluid level of the hydraulic clutch. ( p. 59)
● ● ●
Check the front brake fluid level. ( p. 62)
● ● ●
Check the free travel of the hand brake lever. ( p. 61)
● ● ●
Check the steering head bearing play. ( p. 42)
○ ● ● ●
Check the valve clearance.
○ ●
Check the clutch.
●
Change the cover seal and shaft seal rings of the water pump.
●
Change the engine oil and oil filter, clean the oil screen. ( p. 86)
○ ● ● ●
Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks, and incorrect rout-
ing.
○ ● ● ●
Check the antifreeze and coolant level. ( p. 79)
○ ● ● ●
Check the cables for damage and routing without sharp bends.
● ● ●
Check that the throttle cables are undamaged, routed without sharp bends, and set correctly.
○ ● ● ●
Clean the air filter and air filter box. ( p. 49)
● ● ●
Change the glass fiber yarn filling of the main silencer. ( p. 51)
●
Check the screws and nuts for tightness.
○ ● ● ●
Change fuel screen. ( p. 85)
○ ● ● ●
Check the fuel pressure.
● ● ●
Check idle.
○ ● ● ●
Final check: Check the vehicle for safe operation and take a test ride.
○ ● ● ●
Read out the error memory after the test ride using the KTM diagnostics tool.
○ ● ● ●
Make the service entry in the KTM Dealer.net and in the Service and Warranty Booklet.
○ ● ● ●