12
SERVICE WORK ON THE CHASSIS
67
B01603-11
–
Mount and tighten screws
2
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
Finishing work
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
12.21
Removing the shock absorber
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
B01525-10
Main work
–
Remove screw
1
and lower the rear wheel with the swing arm as far as possible
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
2
, push splash protector
3
to the side, and remove the shock
absorber.
12.22
Installing the shock absorber
x
B01525-11
Main work
–
Push splash protector
1
to the side and position the shock absorber. Mount and
tighten screw
2
.
Guideline
Screw, top shock absorber
M12
80 Nm
(59 lbf ft)
Loctite
®
2701™
–
Mount and tighten screw
3
.
Guideline
Screw, bottom shock
absorber
M12
80 Nm
(59 lbf ft)
Loctite
®
2701™
Info
The heim joint for the shock absorber at the swing arm is Teflon coated. It
must not be greased with grease or with other lubricants. Lubricants dis-
solve the Teflon coating, thereby drastically reducing the service life.
Finishing work
–
Remove the motorcycle from the lift stand. (
12.23
Removing the seat
101346-10
–
Remove screw
1
.
–
Lift up the seat at the rear, pull it back and then remove it from above.