KTM 2009 690 Rally Factory Replica, Руководство пользователя

Страница: 41 / 104

MAINTENANCE WORK ON CHASSIS AND ENGINE
39
8.26
Adjusting the handlebar position
x
0 0
3 3
0 0 2 2
0 0
1 1
0 0 4 4
0 0 5 5
0 0 6 6
0 0 7 7
0 0 8 8
0 0 9 9
400343-10
–
Remove the four screws

. Remove the holding plate with handlebar clamps

with intermediate rubber pieces

and elastomers

.
–
Remove the handlebar and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the lower shells

.
–
Remove the clamp bar

with the rubber cones

.
–
Remove the two screws

. Remove the handlebar support.
–
Place the handlebar support in the required position. Mount and tighten the two
screws

.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
Condition
Spacer

mounted:
Use a M10x35 screw
Condition
Without a spacer

:
Use a M10x25 screw
Info
Position the left and right handlebar supports evenly.
–
Insert rubber cones

and clamp bar

.
–
Insert lower shells

.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the holding plate with handlebar clamp

with intermediate rubber
pieces

and elastomers

.
Elastomer kit green - soft quality (SXS05125203)
Elastomer kit yellow - medium quality (standard) (SXS05125204)
Elastomer kit red - hard quality (SXS05125205)
Info
The elastomers are available in different versions.
–
Mount and evenly tighten the four screws

.
Guideline
Screw, handlebar clamp M8 16 Nm
(11.8 lbf ft)
Info
Make sure the gap width is even.