KTM 2009 690 Rally Factory Replica, Руководство пользователя

Страница: 38 / 104

MAINTENANCE WORK ON CHASSIS AND ENGINE
36
8.20
Dismounting the front fender
600109-10
–
Remove screws

. Remove front fender

.
8.21
Installing the front fender
600109-10
–
Position the front fender

. Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
8.22
Checking play of steering head bearing
Warning
Danger of accidents Unsafe riding behavior due to incorrect steering head bearing play.
–
The steering head bearing play should be adjusted immediately in an authorized KTM workshop.
Info
If the bike is driven for a longer time with play in the steering head bearing, the bearing and the bearing seats in the frame can
be damaged after time.
–
Jack up the motorcycle. ( p. 29)
–
Remove the steering damper.
400189-10
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
» If there is noticeable play present:
–
Adjust play of the steering head bearing
x
( p. 37)
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No
resting locations should be noticeable.
» If click positions are noticeable:
–
Adjust play of the steering head bearing
x
( p. 37)
–
Check the steering head bearing and replace if required.
–
Install the steering damper.
–
Remove the motorcycle from the work stand. ( p. 29)