KTM 200 DUKE 2021, Руководство пользователя

Страница: 71 / 119

WHEELS, TIRES 14
69
–
Clean the contact areas on the brake caliper bracket and link
fork.
–
Mount the damping rubber pieces and rear sprocket carrier on
the rear wheel.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the
chain on the rear sprocket.
S00674-11
–
Pull the rear wheel back and mount wheel spindle
3
with the
washer and chain adjuster
4
.
Guideline
Mount left and right chain adjusters
4
in the same posi-
tion.
–
Mount nut
2
and the washer.
–
Push the rear wheel forward so that the chain adjusters are in
contact with the screws, and tighten nut
2
.
Guideline
In order for the rear wheel to be correctly aligned, the mark-
ings on the left and right chain adjusters must be in the
same position relative to reference markings
B
.
Nut, rear wheel spin-
dle M14x1.5 98 Nm (72.3 lbf ft)
–
Position wheel speed sensor
5
in the hole.
–
Mount and tighten screw
6
.
Guideline
Screw, wheel speed
sensor holder M6 8 Nm (5.9 lbf ft)
Finishing work
–
Remove the rear of the motorcycle from the lifting gear.
(
p. 49)
–
Check the chain tension. ( p. 54)
14.5 Checking rear hub damping rubber pieces
Info
The engine power is transmitted from the rear sprocket to the rear wheel via the 6 damping rubber pieces.
They eventually wear out during operation. If the damping rubber pieces are not changed in time, the rear
sprocket carrier and the rear hub will be damaged.
Preparatory work
–
Raise the motorcycle with the rear lifting gear. ( p. 49)
–
Remove the rear wheel. ( p. 67)