KTM 1290 SUPER DUKE R 2021, Руководство пользователя

Страница: 21 / 188

CONTROLS 6
19
Warning
Danger of accidents The cruise control system function is
not suitable for all riding situations.
The selected target speed will not be reached, if the
engine power is not sufficient for a gradient.
The selected target speed will be exceeded if the engine
braking effect is not sufficient on an incline.
–
Do not use the cruise control systems function on
winding roads.
–
Do not use the cruise control systems on slippery road
surfaces (e.g. rain, ice or snow), where there is poor
visibility or on unpaved surfaces (e.g. sand, stones or
gravel).
–
Do not use the cruise control systems function if the
traffic does not permit a constant speed.
The cruise control system function is only available when motorcy-
cle traction control (
MTC ) is activated.
When motorcycle traction control ( MTC ) is switched off, the cruise
control system function is also switched off.
The cruise control system function cannot be activated during
rapid acceleration.
The cruise control system function can only be activated in third,
fourth, fifth and sixth-gear.
The control range is from 40 to 200 km/h or from 25 to 125 mph.
6.10 +RES/-SET button
S03881-15
The +RES button
1
is fitted on the handlebar, front left.
The
‑
SET button
2
is fitted on the handlebar, rear left.
Info
The +RES and
‑
SET buttons are used to control the cruise
control when the cruise control function is activated.
If the cruise control function is disabled and riding
mode
Performance or Track is set, the +RES and
‑
SET
buttons are used to adjust the Slip Adjuster .
6.11 Combination switch, right
The right combination switch is fitted on the right side of the han-
dlebar.
S03883-11
Overview of the right combination switch
1 C1 and C2 switch ( p. 21)
2 Hazard warning flasher switch ( p. 20)
3 RACE-ON button ( p. 20)
4 Start button/emergency OFF switch ( p. 20)