KTM 125 SX EU 2015, Руководство пользователя

Страница: 92 / 129

17 SERVICE WORK ON THE ENGINE
90
17.3 Draining the gear oil
x
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Only drain the gear oil while the engine is warm.
Preparatory work
–
Park the motorcycle on a level surface.
–
Place a suitable container under the engine.
B02134-10
Main work
(125/150 SX)
–
Remove the gear oil drain plug with magnet

.
–
Remove gear oil drain plug

.
–
Completely drain the gear oil.
–
Clean the gear oil drain plug thoroughly.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet

and the seal ring and tighten.
Guideline
Gear oil drain plug with magnet M12x1.5 20 Nm
(14.8 lbf ft)
–
Mount gear oil drain plug

with the seal ring and tighten.
Guideline
Gear oil drain plug M10x1 15 Nm
(11.1 lbf ft)
B02133-10
(All 250/300 models)
–
Remove the gear oil drain plug with magnet

.
–
Completely drain the gear oil.
–
Clean the gear oil drain plug with the magnet thoroughly.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet

and the seal ring and tighten.
Guideline
Gear oil drain plug with magnet M12x1.5 20 Nm
(14.8 lbf ft)
17.4 Refilling with gear oil
x
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.