KTM 125 SX EU 2015, Руководство пользователя

Страница: 78 / 129

14 ELECTRICAL SYSTEM
76
14.1 Removing the battery
x
(All XC models)
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Preparatory work
–
Switch off all power consumers and the engine.
–
Remove the seat. ( p. 48)
B02135-10
Main work
–
Disconnect negative cable

from the battery.
–
Pull back the positive terminal cover

and disconnect the positive cable from the
battery.
–
Detach rubber band

at the bottom.
–
Lift the battery up.
14.2 Installing the battery
x
(All XC models)
B02136-10
Main work
–
Insert the battery into the battery compartment with the terminals facing to the
front.
Battery (YTX4L-BS) ( p. 113)
–
Attach rubber band

.
–
Position positive cable

, and mount and tighten the screw.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Info
Contact disks

must be mounted between screws

and cable sock-
ets

with the claws facing down.
–
Slide positive terminal cover

over the positive terminal.
–
Position negative cable

, and mount and tighten the screw.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Finishing work
–
Mount the seat. ( p. 48)