KSB Guard, Инструкция по установке и эксплуатации

Страница: 24 / 40

5 Installation/Commissioning
24 of 40
KSB Guard
Required data Example Notes
Optional: Optimum flow rate 50 m³/h
Optional: Specification of 7 reference points on
the characteristic curve
25 kW, 25 m³/h, 25 m;
20 kW…
ü The KSB Guard app is installed on the mobile device.
ü Data as per table The data required to register the pump set in the KSB Guard app is
available.
1. Start the KSB Guard app or open the KSB Guard Web Portal
( www.ksbguard.net ).
2. Select the Add Pump function in the app menu or on the web portal.
3. Follow the instructions in the app dialogue or on the web portal and enter the
requested information.
4. Save the assignment.
NOTE
The limit values for the pump set are set automatically. Default values can be
checked and, if necessary, changed in the individual view screen of the pump.
NOTE
Once the link has been established, 2 measuring cycles must be run through until
the data transferred from the pump set can be viewed on the web portal or in the
app. This process takes 2 hours at minimum for hourly data transfer (default
setting). If 2 measurements are triggered manually (
ð
Section 6.2, Page 25) , the
data can be viewed in just a few minutes’ time.