5 Installation at Site
37 of 64
Evamatic-Box N
13. Fasten the power cable.
Protrusions for inserting the screws are provided on the outside of the tank. Use
these precise positions when fitting the clamp holders.
14. Pull the power cable through cable grommet 916 and press the cable grommet
into its seat.
5.5.2 Evamatic-Box N 200 l — stationary version, with Ama-Porter
Fig. 16:
Installing the pump and piping
Fig. 17:
Cable grommet
1. Cut the cover of the seat for cable grommet 916 open with a 45 mm diameter
hole saw.
2. Debur the edges and smoothen the surface until the diameter equals 46 ±
0.5 mm.
Alternatively, for tanks installed underfloor, the power cable can be guided
through the vent nozzle. In this case, do not alter the original condition of the
cable grommet seat.
3. Fasten clamp holder 81-73 to the tank with the screw supplied for this purpose.
(A protrusion for inserting the screw is provided on the outside of the tank. Use
this precise position when fitting the clamp holder.)
4. Fasten the clamp to clamp holder 81-73 and tighten it.
5. Attach hook 59-18 to the clamp.
6. Fasten the shackle and chain 885 to the pump handle.
7. Lower the pre-assembled piping into the tank and position the baseplate on the
protrusion provided for this purpose. (
8. Slide outlet pipe 710-1 into elbow 13-18 until it will not go any further. Secure it
with glue.
9. Attach chain 885 to hook 59-18.
10. Fasten claw 732 to submersible motor pump 655 with bolt 901-1.
11. Guide the claw into the hoop and slowly lower the pump into the tank.
12. Fit the three supplied clamp holders for fastening the power cable in the tank.
