KSB Amarex N, Руководство по эксплуатации

Страница: 27 / 72

5 Installation at Site
27 of 72
Amarex N
Table 13: Types of attachment
Drawing Type of attachment
59-18
885
59-17
UG1274869
Shackle with chain at the pump casing
59-17 Shackles
59-18 Hook
885 Lifting chain/rope
59-18
885
59-17
571
UG1274897
Shackle with chain at the lifting bail
59-17 Shackle
59-18 Hook
571 Lifting bail
885 Lifting chain/rope
5.3.1.7 Installing the pump set
NOTE
For pumping water containing sludge and suspended solids pump sets with impeller
type S (cutter) are preferable. In such cases using an inclined claw is recommended.
NOTE
Make sure the pump set with the pre-assembled claw can easily be slipped over the
mounting bracket, threaded onto the guide rails and lowered down. If required,
alter the position of the crane during installation.
1.
Guide the pump set over the suspension bracket/mounting bracket, thread it
onto the guide wires/rails and slowly lower it down.
The pump set attaches itself to duckfoot bend 72-1.
2.
Attach the lifting chain/rope to hook 59-18 at the mounting bracket.
5.3.2 Transportable wet installation
Before installing the pump set, fit the 3 pump feet and foot plate, if applicable.
Fitting the pump feet
1.
Undo screws 914.03.
2.
Guide pump feet 182 into the opening in the suction cover.
3.
Tighten screws 914.03 again to the indicated tightening torque.
(
ð
Section 7.6, Page 52)
Fitting the foot plate
1.
Fit the foot plate to the three pump feet with screws, discs and nuts. Observe
the tightening torques.
(
ð
Section 7.6, Page 52)