Place the third deck upon the second deck assembly.
Slide in the 4 leg caps, making sure the socket head
screws glide into their respective holes. Wiggle
everything a little, the caps should find their way flush
against the deck.
Tighten the socket head screws. Do not over tighten.
Install the gold colored bearing well using the
supplied 10-32 socket head screws. Do not over
tighten. Add 8 ml. of Kronos bearing oil. Make sure
the bearing shaft is oiled. Place the bearing ball on
top of the bearing shaft. Make sure it does not fall in
the bearing well.
Carefully deposit the top platter (the one with the
spindle) onto the bearing shaft.
The platter
should rotate freely.
If it does not, remove
the platter and make sure the ball is on top of the
bearing shaft.
Install the top pick up pulley. Grease the pulley shaft
and also grease the shoulder of the shaft assembly.
Insert the pulley. Do not over grease. Once every 6
months or so, the pulley can be removed, cleaned
(along with the shaft) and re-greased. This will insure
better speed stability. Install the 3 belts as in step 10.
Install the tone arm board specified for the particular
tonearm you will be using. Install your tonearm using
a proper protractor and make adjustments.
Remove the white leg spacers by cutting the tie wraps.
Keep the spacers in a safe place, you will need them
if you need to move the Kronos, or if you need to
disassemble it for transport. Additional tie wraps have
been supplied for such an eventuality.
It is very
important that the Kronos not be moved
without installing the white spacers.
Failure to do so could damage the speed
sensors located left of the platters.
11
15
12
16
13
17
14
18
