Krone Vendro 680, Руководство по эксплуатации, Страница: 66 / 104

9 Driving and transport
9.2 Reducing the transport width
66
Vendro 680
Original operating instructions 150001223_01_en
9.2 Reducing the transport width
1
2
3
KWG000-034
To reduce the transport width, connect the outer wheels (1) under the rotors in the lower
borehole of the wheel arm (2) (flat spreading angle).
„
Pull the spring-loaded bolt (3).
„ Swivel the wheel (1) to the lower borehole of the wheel arm (2).
„
Engage the spring-loaded bolt (3).
9.3 Parking the machine
The machine can be parked in transport position or in working position.
„ Park the machine on a stable, horizontal and even surface.
„
To park the machine in working position, move the machine into working machine, see
Page 58 .
„ To park the machine in transport position, move the machine into transport position, see
Page 59 .
„
Move the front support jack into support position, see Page 57 .
„ Move the rear support jack into support position, see Page 57 .
„
Set the control units to the float position.
„ Switch off the tractor engine, remove the ignition key and take it with you.
„
For version with "Road travel lighting": Pull the 7-pin plug of the connection cable out of
the 7-pin socket of the tractor and place it on the machine.
„ For version with "Night swathing gearbox": Loosen the supporting chain of the universal
shaft on the tractor side.
„
Disconnect the universal shaft on the tractor side and put it down on the designated holding
fixture.
„
Depressurise the tractor hydraulics.
„ Uncouple the hydraulic hoses from the tractor, attach the dust caps and hook the hydraulic
hoses onto the support / holder of the machine.
„
Detach the top link.
„ Detach the lower links of the tractor and lower them so that the tractor can be driven away
safely.