Safety
2
Basic safety instructions
2.4
Vendro 680
Original operating instructions 150001223_01_en
15
Technical limit values
If the technical limit values of the machine are not observed, the machine may be damaged. As
a result, accidents may occur and people may be seriously or fatally injured. With regard to
safety, it is especially important to observe the following technical limit values:
•
maximum permitted operating pressure of the hydraulics
•
maximum permitted drive speed
•
maximum permitted total weight
•
maximum permitted axle load/axle loads
•
maximum permitted drawbar load
•
maximum permitted axle loads of the tractor
•
maximum permitted transport height and width
•
maximum permitted speed
2.4.10
Danger zones
If the machine is switched on, its surrounding can present a danger zone.
Avoid entering the danger zone of the machine by observing the minimum safety distance.
If the safety distance is not observed, people may be seriously injured or killed.
Do not switch on the drives and engine if the minimum safety distance has not been
observed.
If people fail to observe the minimum safety distance, switch off the drives.
Switch the machine off in shunting and field mode.
The safety distance is:
For machine in shunting and field mode
In front of the machine
30 m
Behind the machine
5 m
On either side of the machine
3 m
For machine switched on without driving motion
In front of the machine
3 m
Behind the machine
5 m
On either side of the machine
3 m
The safety distances specified here are minimum distances in terms of intended use. If
necessary, these safety distances must be increased according to the operating and ambient
conditions.
Before working in front of and behind the tractor and in the danger zone of the machine:
Shut down and secure the machine,
. This also applies to brief inspection
work.
Consider the information in all relevant operating instructions:
•
the operating instructions of the tractor
•
the operating instructions of the machine
•
the operating instructions of universal shaft