Settings
252
Pos: 50.29.1 /Ü berschriften/Ü berschriften 3/K-O/NN etzbremse ei nstellen @ 33\mod_1253794584738_78.docx @ 317751 @ 3 @ 1
15.1.6
Adjusting the net brake
Pos: 50.29.2 /BA/Ei nstellungen/R undball enpresse/Netz Einstell ung enN etzbremse ei nstellen_Bild @ 235\mod_1394117474321_78.docx @ 1868133 @ @ 1
VP-3-019
0 -
50
m
m
1
2
a
3
Fig. 206
Pos: 50.29.3 /BA/Ei nstellungen/R undball enpresse/Netz Einstell ung enN etzbremse ei nstellen_T ext @ 33\mod_1253794736488_78.docx @ 317772 @ @ 1
Note
If the net is caught during baling, tension on the net brake spring (1) must
be increased.
In the default setting the dimension of the clamping screw should be
a = 35 mm
.
The spring (1) of the brake can be adjusted on the ring bolt (2).
If the net is not being drawn in correctly at the start, the pressure of the idler roller can be
increased with the spring (3).
Pos: 50.29.4 /BA/Ei nstellungen/R undball enpresse/Netz Einstell ung enN etzbremse ei nstellen_Hi nweis @ 235 \mod_1394113766805_78.docx @ 1867752 @ @ 1
Note
The net brake setting depends on the type of net being used. The net brake should be set in
such a way that after the tying process the net hangs into the channel by approx. 0 - 50 mm
over the scraper. Always use a speed of 540 rpm for wrapping.
Pos: 50.30 /Layout Module /---------------Seitenumbr uch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
