Krone Comprima F 155 XC, Оригинальная инструкция по эксплуатации, Страница: 81 / 278

Operation 8
Crop press roller unit 8.13
Comprima F 155 XC
Original Operating Instructions 150001050_01_en 81
When used in straw, the pick-up should be set as high as possible off the ground. Then use the
chain (3) to adjust the guide wheels of the pick-up so that they do not touch the ground.
ü The machine is shut down and safeguarded, refer to page 27 .
ü
The pick-up is fully raised in transport position, refer to page 79 .
ü
The guide wheels are folded upwards.
Make the following setting on the right and left sides of the machine in the same way:
„
Open the side hood.
„ Remove the linch pin (2).
„
Attach the chain (3) higher or lower by one complete chain link or attach the required chain
link in position (I), (II) or (III).
„ Mount the linch pin (2).
„
Check whether the drawbar height of the machine must be adjusted to the tractor, refer to
page 47 .
8.12.3 Adjusting the bearing pressure relief for the pick-up
X
1
2
3
RPG000-128
To be able to negotiate uneven ground better, the pick-up is relieved on both sides of the
machine with the aid of a spring (3). The spring (3) can be set on the ring screw (2).
KRONE recommends the following setting:
• Dimension X (left side of machine): 150 mm
• Dimension X (right side of machine): 42 mm
ü
The guide wheels have been adequately relieved.
„ On the right and left sides of the machine check whether the aforementioned dimensions
match.
„
If required, screw in or unscrew the nut (1) until the aforementioned dimension X has been
set.
8.13 Crop press roller unit
WARNING
Risk of injury if the machine is used without a crop press roller unit
The crop press roller unit is used for accident protection! If the machine is operated without a
roller crop guide, people can be seriously injured or killed.
„ Never operate the machine without a crop press roller unit.