Krone Comprima F 155 XC, Оригинальная инструкция по эксплуатации, Страница: 229 / 278

Malfunction, cause and remedy 19
Faults of the electrics/electronics 19.5
Comprima F 155 XC
Original Operating Instructions 150001050_01_en 229
19.5.2 Overview of fuses
The circuit board with the fuses is located on the right side of the machine behind the side hood.
As indicated on the circuit diagram, the following fuses are on the circuit board:
RPG000-080
Designa-
tion Explanation Designa-
tion Explanation
A1.F1 Reserve A1.F7 PWR plug X551
A1.F2 KMC A10 PWR UB1 A1.F8 KMB A30 / A31 PWR UB
A1.F3 KMC A10 PWR UB2 A1.F9 KMC A10 ECU_PWR
A1.F4 Reserve A1.F10 ISOBUS expansion ECU PWR
A1.F5 ISOBUS expansion PWR A1.F11 ECU plug X551
A1.F6 Reserve
19.5.3 Remedying sensor/actuator error
Components must be repaired or replaced by a qualified specialist workshop only.
Before contacting the dealer, collect the following information about the error message:
„ Note the error number and the respective FMI ( refer to page 227 ) that are shown on the
display.
„
Shut down and safeguard the machine, refer to page 27 .
„
Check sensor/actuator externally for damage.
Æ
If the sensor/actuator is damaged, replace the sensor/actuator.
Æ If the sensor/actuator is not damaged, continue with the next test step.
„
Check connector cable and plug connection for damage and tightness.
Æ If the connector cable/plug connection is damaged, replace the connector cable/plug
connection.
Æ
If the sensor/actuator is not damaged, continue with the next test step.
„ Perform an actuator test in case of an actuator error to identify the actuator status, refer to
page 159 .
„
If a sensor is defective, run a sensor test to identify the sensor status, refer to page 155 .
The more information the dealer has, the easier it is to eliminate the cause of the error.
19.5.4 Error list
General aspects on error causes