Krone Comprima F 155 XC, Оригинальная инструкция по эксплуатации, Страница: 178 / 278

17 Settings
17.8 Checking and setting the axial play of the brake disc at the wrapping material brake
178
Comprima F 155 XC
Original Operating Instructions 150001050_01_en
17.8 Checking and setting the axial play of the brake disc at the wrapping
material brake
4 5
2 3 1
3
6
X
4
RP000-023
The axial play of the brake disc (4) on the wrapping material brake must be adjusted, etc.,
before setting the sensor B02 "Tying process active ",
refer to page 155 .
The axial play must be X=1–2 mm .
„
To release the wrapping material brake, press the lever (5) downwards.
„
Measure the axial play X of the brake disc (4) to the adjusting collar (1).
If the axial play is not X=1–2 mm :
„
Raise the lever (6).
„
Swivel the brake disc (4) with the roll holder (3) forwards and pull off the brake disc (4).
„
Loosen the threaded pin (2) and dismount the adjusting collar (1).
„
Use shim rings to set the required axial play X.
„ Mount the adjusting collar (1) and tighten the threaded pin (2).
„
Push the brake disc (4) onto the roll holder (3) and swivel it back into the machine.