Krone Comprima F 125 XC-1, Руководство по эксплуатации

Страница: 300 / 374

7 Terminal menus
7.21 Menu 15 "Settings"
56
Comprima F 125 - 1, Comprima F 125 XC - 1, Comprima F 155 - 1, Comprima F 155 XC - 1, Comprima V 150 - 1,
Comprima V 150 XC - 1, Comprima V 180 - 1, Comprima V 180 XC - 1, Comprima V 210 XC - 1
Comfort 1.0_en
7.21.1.3 Adjusting sensor B09/B10 “Filling display left/right”
Comprima V
15-1
1
state:
2,4V
1,9V
3,2V 1,9V
B08
B09
L
B10
R
1
2
3
EQG003-042
The sensor (3) is located behind the side hood:
• B09 on the left side of the machine
• B10 on the right side of the machine
The green bar in menu 15-1 “Sensor test” shows the saved value. The black bar shows the
current value of the sensor. As soon as a new value is saved, the green bar is adjusted to the
black one.
ü
The bale chamber is closed and empty.
ü The density of the bale core is set in position III – “Low density of the bale core”, see
operating instructions, chapter Operation, “Adjusting the density of the bale core”.
ü
Menu 15-1 “Sensor test” is open.
ü
Sensor B09 or B10 has been selected.
If the bar (2) is not inside the rectangle (1) when the bale chamber is closed and empty, adjust
sensor B09 or B10 mechanically:
„
Loosen the screw connections of the sensor and move it in the oblong hole until the bar (2)
is inside the rectangle (1) of the bargraph in the display.
ð
An audio signal sounds if the bar (2) is inside the rectangle (1).
„
Tighten the screw connections on the sensor .
„ Press .
Æ
The set position is saved.
INFORMATION
Saving is only possible if the bar (2) is inside the rectangle (1) of the bargraph.
7.21.1.4 Adjusting sensor B61 “Tying 1 (passive)”
The following positions are saved with sensor B61 “Tying 1 (passive)”:
• The feed position,
• the cutting position and
• the tying position.