Krone BiG Pack 870 HDP XC, Оригинальная инструкция по эксплуатации

Страница: 196 / 410

15 Settings
15.4 Setting the knotter needles
196
BiG Pack 870 HDP XC
Original Operating Instructions 150000760_00_en
Much crops: Attach the chain to a shorter
position. The crop press roller unit has
been raised higher.
Sparser crops: Attach the chain to a longer
position. The crop press roller unit has
been lowered into a deeper
position.
ü The machine is shut down and safeguarded, refer to page 25 .
„
Set the height of the crop press roller unit (1) so that the crop press roller (2) runs
continuously above the swath.
„ If there is plenty crop, attach the chain (3) to the holder (4) in a shorter position.
Æ
The crop press roller unit has been raised higher.
„ If there is sparser crop, attach the chain (3) to the holder (4) in a longer position.
Æ
The crop press roller unit has been raised higher.
„
Check if the chains (3) are attached to the holders (4) with the same length on both machine
sides.
Setting the bearing pressure of the crop press roller
2
1
3
BPG000-068
The spring (1) sets the bearing pressure of the crop press roller (2) to the swath.
Dry crops: Increase the bearing pressure.
Moist crops: Reduce the bearing pressure.
ü
The machine is shut down and safeguarded, refer to page 25 .
„ In order to increase the bearing pressure, loosen the nut (3).
„
In order to increase the bearing pressure, loosen the nut (3).
15.4 Setting the knotter needles
15.4.1 Setting the lateral guidance of the knotter needles
NOTICE
Machine damaged because the needle yoke has not been checked after setting the
knotter needles
„ After setting the knotter needle pass once manually through the tying process. refer to
page 111 .
„
In doing so, the knotter needles and needle yokes must not come in contact with the
frame, plunger or other parts during the upward or downward motion.