Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 275 / 448

Maintenance - Lubrication 18
Lubricating rolls for the blade lever 18.2
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 275
Listing of lubricating greases to be used, refer to page 61 .
The following table provides information on lubrication quantity and interval per lubrication point.
Pos. Lubricant quantity Lubrication interval
(1) 26 g 50 hours
(2) 100 g
(3) 32 g
(4) 6 g
18.2 Lubricating rolls for the blade lever
BP000-269
„
Lower the blade cassette, refer to page 266 .
„ Shut down and safeguard the machine, refer to page 26 .
„
Releasing the single blade locking device, refer to page 266 .
„ Pull out the blade cassette, refer to page 267 .
„
Lubricate all grease nipples (2).
„ Push in the blade cassette until the locking lever (1) engages automatically.
„
Lift the blade cassette, refer to page 267 .
18.3 Lubrication chart - machine
The information on maintenance intervals is based on average load of the machine. In case of
an increased load and under extreme working conditions, the time periods must be reduced.
The types of lubrication are marked by means of icons in the lubrication chart, refer to table.
Type of lubrication Lubricant Note
Grease Multi-purpose grease • Two strokes from the
grease gun per grease
nipple.
• Remove superfluous
grease at the lubrication
nipple.
Lubrication Unless otherwise prescribed,
use oils based on vegetable
matter. • Thinly apply with brush or
aerosol can on the sliding
surface.
• Remove old and
superfluous oil.